The 1-to-100 change list
Example, marked
1What I did by hand
| Done by hand once | At a hundred | Change in the file |
|---|---|---|
| Trimmed a corner tab | a hundred tabs | shorten the tab |
| Shimmed the base | a hundred shims | thicken the base |
| Cut a notch for the rail | a hundred notches | draw the notch in |
2Freeze one version
File and date I approvebin_v4, 2 November
Any later change gets a new name.
3Material
Prototype materialPLA
- The run must take
- heat
- Ticked: load
- sun or water
4Fits that must hold
Fitssits in the drawer grid, bins side by side
Try the first few in the real drawer.
5The route
- Ticked: Print again
- silicone mold and pour
- a mold shop
- not sure
How many100
The 1-to-100 change list ยท LOUEI 3D PRINT
Before you contact any shop
Have these ready. Any shop will ask for most of them.
- Photos: the whole part on plain paper, the same view with a ruler beside it, and the break up close.
- The sizes you can measure, and what the part fits onto or into.
- Where the part lives and what it does.
- How many you need.
- Any file or drawing you have, even an old one.
At LOUEI 3D PRINT you can start from anything: an idea, a sketch, a photo, CAD, measurements, the broken part itself or a previous order. We read STEP, STL, OBJ, IGES, DXF, PDF drawings and photographs.